Pro AV Catalog

< Back to Previous Page

Home : Audio Production Equipment : Klark Teknik - SQ1D

All Products

Square One 8 Channel Dynamics Processor

Model: SQ1D

Provide eight complete channels of either compression or gating, with push button selection
LED status indication of operational mode on an individual channel basis
Compressor section on each channel shall provide for adjustment of threshold, make-up gain, attack and release times and ratio
RMS or Vintage emulation (peak) response and push button selection of soft or hard knee mode on each channel
Gate section on each channel shall provide for adjustment of threshold, attack, hold and release times and range

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Provide eight complete channels of either compression or gating, with push button selection.LED status indication of operational mode on an individual channel basis, compressor section on each channel shall provide for adjustment of threshold, make-up gain, attack and release times and ratio, RMS or Vintage emulation (peak) response and push button selection of soft or hard knee mode on each channel, gate section on each channel shall provide for adjustment of threshold, attack, hold and release times and range. Each channel shall have a six-segment input level meter and ten-segment attenuation depth meter, which will show the gain reduction being applied in both compression and gating modes. Each channel shall have a sidechain band-pass filter with rotary control knob for frequency control and shall be enabled by push button switch.

Provide eight complete channels of either compression or gating, with push button selection
LED status indication of operational mode on an individual channel basis
Compressor section on each channel shall provide for adjustment of threshold, make-up gain, attack and release times and ratio
RMS or Vintage emulation (peak) response and push button selection of soft or hard knee mode on each channel
Gate section on each channel shall provide for adjustment of threshold, attack, hold and release times and range
Each channel shall have a six-segment input level meter and ten-segment attenuation depth meter, which will show the gain reduction being applied in both compression and gating modes
Each channel shall have a sidechain band-pass filter with rotary control knob for frequency control and shall be enabled by push button switch
Band-pass filter shall have two different bandwidth settings, selectable by a push button switch
There shall be provision for an external sidechain input selected by the external key switch with LED status indication
Bypass switch shall set the signal path to unity gain on each channel and provide LED status
Each channel shall have solo switch with LED status indication that sends sidechain signal to solo bus output connector
Solo bus input connector shall allow multiple dynamics units to be chained together to form a common solo bus output

Depth: 8 in
Height: 5.25 in
Width: 19 in
Product Weight: 9.70 lbs
Shipping Weight: 11.90 lbs
Sampling Rate/Frequency: 20 kHz
Sampling Rate/Frequency: 20 Hz
Sampling Rate/Frequency: 0 Ghz
Input Impedance: 5000 ohm
Number of Audio Channels: 8
Output Impedance: 50 ohm
AC Voltage: 240 Volts
Active Power: 35 Watt
Inputs: 8 (mic/line)
Input Type: Analogue, electronically balanced, female XLRs (Pin 2 hot)
Maximum Input Level: +22dBu
Input Impedance: 5 kohms
Common Mode Rejection: -80dB at 1kHz (typical), unity gain (0dB)
ratio (CMRR): -100dB at 1kHz (typical), maximum gain (+40dB)
Outputs: 16(rear panel)
Operating Level: 0dB
Maximum Level: +22 dBu
Output Impedance: <50 ohms
Signal drive capacity: <600 ohms
Headphone Output: 1
Rating: 750 mW (nominal 50ohm load)
Audio: Front panel connectors
Channel Input: Eight x AA series female XLRs (labelled "IN 1" to "IN 8")
Isolated output C: Eight x AA series male XLRs (labelled "TX OUT 1" to "TX OUT 8")
Electronic output A: Eight x AA series male XLRs (labelled "OUT A")
Electronic output B: Eight x AA series male XLRs (labelled "OUT B")
Power: 3-pin IEC
Frequency Response: ±0.5dB (input to output), 20Hz to 20kHz
Distortion: <0.02% at 1kHz, 0dBu at unity gain
Dynamic Range: >122 (electronically balanced outputs) and >140 dB (transformer isolated outputs)
Noise Floor Unity gain: <-100 dBu
Mic EIN a5 +40dB gain: <-128 dBu
High pass filter frequency: -3dB at 30Hz
Filter slope: 12 dB/Octave
Number of Inputs: 8
Number of Outputs: 16